Plastiques &
élastomères

Plus d'info

Peintures, vernis, adhésifs, encres et revêtements

Plus d'info

Détergents et produits d’entretien

Plus d'info

Cosmétiques et produits d’Hygiène Corporelle

Plus d'info

Industrie Pharmaceutique

Plus d'info

» Accueil » Plastiques & elastomers



Plastiques & elastomers

TECHNOLOGIES

LIENS UTILES

Visiter notre site web

Point focal REACH-CLIP

Nos Publications

Esp@cenet

WIPO-OMPI

INNORPI

L’agence de promotion de l’industrie et de l’innovation

Ministère de l’industrie

Filtrer par Mois: Année: [Voir tous]
Date Titre
02/01/2024

Evaluation of solubility parameters and relative energy difference (RED) on the preparation of polysulfone/polyethylene glycol membrane: A study on the casting solution and coagulation bath

17/11/2023

State-of-the-art of polyimide films reinforced with fullerene-design, features and applications

04/02/2022

Microorganisms, Vol. 10, Pages 362: Reactivation of Herpes Simplex Virus Type 1 (HSV-1) Detected on Bronchoalveolar Lavage Fluid (BALF) Samples in Critically Ill COVID-19 Patients Undergoing Invasive Mechanical Ventilation: Preliminary Results from Two Italian Centers

21/01/2022

Experimental and Theoretical Yield Strength of Silicon Carbide and Hexagonal Boron Nitride Reinforced Mg-Zn Nanocomposites Produced by the Combined Effects of Ultrasonication and Squeeze Casting

17/01/2022

Influence of Silicon Addition on Mechanical Properties and Wear Behaviour of AZ91D Magnesium Alloy Using Stir Casting Method

31/12/2021

[ASAP] Improvement of Thermoelectric Properties via Texturation Using a Magnetic Slip Casting ProcessThe Illustrative Case of CrSi2

23/12/2021

Graphene oxide-Fe3O4 nanocomposite used as aniline adsorbent with a wide pH range

20/12/2021

[tel-03494705] Développement de nouveaux solvants de lavage pour l'absorption des Composés Organiques Volatils

13/12/2021

Applied Sciences, Vol. 11, Pages 11824: Effects of Post-Treatment to Improve the Surface Quality of 3D Printing Cement Mold Casting

13/12/2021

[tel-03476471] About the optimality of competition among health-care providers

25/11/2021

Metals, Vol. 11, Pages 1895: Permeability Measurements of 3D Microstructures Generated by Phase Field Simulation of the Solidification of an Al-Si Alloy during Chill Casting

23/11/2021

Metals, Vol. 11, Pages 1886: Comparison of the Flow Field in a Slab Continuous Casting Mold between the Thicknesses of 180 mm and 250 mm by High Temperature Quantitative Measurement and Numerical Simulation

11/11/2021

Experimental Investigation on Microstructural and Mechanical Attributes of Al 7075-T6/SiC/CR/MoS2 Based Green Hybrid Composite Via Advanced Vacuum-Sealed Bottom Pouring Stir Casting

22/09/2021

Investigation on the Influence of Polyethylene Wax Powder on the Characteristics of Ceramic Shells Used for Investment Casting

24/08/2021

Sensors, Vol. 21, Pages 5681: Sensors Application of Simulated Arms with Real-Time Pressure Monitor in Casting and Splinting by Physiological Sensors

Enregistrements: 110 - Nº Pages: 8